November 16, 2026 · Buffalo Insulation
How Much Attic Insulation Do You Need in Buffalo?
The attic is where most Buffalo homes lose the most heat. Here's how much insulation you actually need and how to tell if you have enough.

The target: R-49 to R-60
For cold climates like ours, the U.S. Department of Energy recommends attic insulation in the R-49 to R-60 range. With blown-in insulation, that's roughly 14 to 18 inches.
Many older Buffalo homes have far less, often 4 to 8 inches that has settled over the decades.
How to check your attic
If you can see the tops of the ceiling joists, you almost certainly need more. Dark or dirty spots in the insulation usually mean air is leaking up from the house there.
Air sealing comes first
Adding insulation over air leaks only goes so far. Seal the top plates, wiring and plumbing holes, chimney chase and attic hatch first. That's where warm air escapes, and where ice dams start.
Measuring what you have
Take a tape measure into the attic and check the depth in several spots, since insulation is often uneven. Loose fiberglass gives about R-2.5 per inch and cellulose about R-3.5 per inch. Six inches of old fiberglass is roughly R-15, far short of what a Buffalo home needs.
Common problems to look for
Look for insulation pushed back from the eaves, gaps around the attic hatch, open wall tops in older homes, recessed lights poking through, bath fans venting into the attic, and frost or water stains on the underside of the roof. Fix roof leaks and venting problems before adding insulation.
Half-story attics
In capes and bungalows, the attic is split into small spaces behind the knee walls and a flat area above the upstairs ceiling. Each one needs to be sealed and insulated. The sloped ceilings in between are often the hardest part, and sometimes dense-pack or spray foam is the only practical option there.
What it costs
See our attic insulation cost page for typical price ranges. The exact price depends on attic size, how much sealing is needed and the depth you're aiming for, so an on-site estimate gives you the real number.
Key takeaways
Aim for the DOE's guidance: about R-60 for an uninsulated attic, or adding about R-49 over a few inches of existing insulation. Seal air leaks first, keep soffit vents open, and confirm depth with markers. If you can see your ceiling joists, it's time to add more.
Get a free estimate
Call (716) 625-3353 or send the form and we'll come take a look, anywhere in Buffalo and Western New York.